gray prada sneakers doudoune prada pas cher paris femme france

gray prada sneakers pants are too long, you can use this tutorial series, which will show you how to professionally alter your pants. Cut off the excess, and then resew a stylish new hem.How to Make Beaded HandbagsLay the envelope purse you want to make into a beaded handbag on the tissue paper. Draw around the purse using the soft lead pencil. Draw another outline about a 12 inch wider than the one you just traced. Fold the tissue in half and cut your new purse pattern out of the tissue paper, following the widest outline. Decide which part of the pattern on the fabric you want accented with beads. Thread your needle, knot the thread and pick up a sequin on the needle tip. Push the sequin down to the knot and pull the needle through to the right side of the fabric. This leaves the sequin on the wrong side of the fabric, where it will hold the weight of the bugle beads much better than just a knot of thread. Again place a sequin on the needle tip and slide it up the thread length until it's lying flat against the fabric. Pick up two or three bugle beads on the needle, and slide them up the thread length to the sequin. Push the needle back through both sequins and knot the thread on the inside of the first sequin. You've just created your first bead "dangle" for your purse. Once you have all the beading in place that you want, match the edges of the fabric to the purse.How to Make and Repair HandbagsIf you can sew a straight line using a sewing machine, then you can make a handbag. A simple handbag takes only a few hours to complete. It requires no pattern, and little in the way of advanced sewing techniques. It makes a stylish gift or treat for yourself, and can cost much less than buying a designer bag at a store. Also, once you have the basics of bag making, it's an easy transition to repairing common handbag damage. A broken strap or a snap that has fallen apart is no reason to toss a favorite handbag.Find the middle of the lining on each side and measure down an inch from the top. Place the top of the interfacing squares at this mark on the wrong side of the lining. Iron the squares in place. Take one side of your magnetic snap and gently press the two prongs into the interfacing so