coach black friday sale doudoune coach pas cher paris femme france

coach black friday sale kept the pieces. My idea is to straighten the track pieces and then weld them to the end of a rod of iron and use it as cutting tools for the lathe. But for now, I just try to take advantage of the balls, the way I will explain.La bolita mide casi 8 mm de di As que hice un agujero de esa medida en una varilla de hierro. Luego avellan ambos lados del agujero, y cort con la amoladora el borde del agujero m cercano al extremo de la varilla. Con algunos martillazos logr que la bolita de acero quedara firmemente apretada dentro del agujero.The ball gage is about 8 mm. So I made a hole of that diameter in a rod of iron. Then countersink both sides of the hole, and cut with the grinder the edge of the hole near the end of the rod. The product was named Mil Agro (milagro=miracle) and was really awesome. But after a seek last year, I can't find it nor any similar.I asked at "La Casa del Soldador" (welder's house) and they sold me stainless steel electrodes. They are expensive, difficult to use, and I don't think are so hard as a ball bearing.Today I feel a bit better, the day is sunny and mild, so I will try to launch my forge to straighten a broken ball bearing. Then I will post the result, obviously.By now you've realized that my motivation is not doing something technically right, or most convenient, but just experiment and have fun. Otherwise, it would have been better to go to La Plata and buy two or three good cutting tools, they aren't so expensive.Cutting Lining for Inside of BagNow I'm going to show you how to make a lining for our recycled jeans handbag. I'm using a skirt that I'm recycling for